Filter
Top Products
3. Using the Web Interface
6388-A2-GB20-00 February 2005
3-5
Setup
To set up LAN and WAN options not available on the Quick Start screens, select
Setup from the Home page. Figure 3-6 shows the Setup page. The menu is
broken into two sections: the WAN configuration and the LAN configuration.
Figure 3-6. Setup Options
Wide Area Network Connection
The DSL (LINE) connection is the Wide Area Network (WAN) connection. It is also
referred to as a broadband connection. The requirements for the WAN connection
depend on your Internet Service Provider (ISP). Most of the configuration you will
perform will be in this area.
Local Area Network Connection
On the other side of your router are your own Local Area Network (LAN)
connections. This is where you plug in your local computers to the router. The
router is normally configured to automatically provide all the PCs on your network
with Internet addresses.
If you connected a PC (rather than a hub or a switch) directly to the router, your
LAN consists of that PC.
Saving Changes
Note that the Apply button temporarily saves changes you make. To make
changes permanent, click on Tools (at the top of the page) and select System
Commands. At the System Commands page, click on Save All.