Filter
Top Products
OnSite System Installation 31
OnSite Series Getting Started Guide 3 • Installation Overview
Note Do not cover vents that would restrict airflow. Leave a minimum of a
half-rack space above and below the OS-10 system for adequate ven-
tilation.
3. Secure the chassis using four 12-24 x 3/4-inch screws (two screws for each side) through the elongated
holes in the L bracket nearest to the chassis and to the threaded holes in the mounting post. Use a suitable
screwdriver for this task.
4. Tighten any loose captive installation screws on the expansion slot front panel covers.
Figure 11. Mounting the OS-10 System in an ETSI 300-mm Rack