Filter
Top Products
23
• dsl set errmon startdelay <startdelay>: Sets the number of seconds
to wait after the DSL link comes up before the error monitor starts
inspecting intervals.
The following commands display the current DSL configuration:
• dsl show annex: Shows the currently selected G.SH Annex.
• dsl show lineprobe: Shows whether or not Line Probe is
currently enabled.
• dsl show loopback: Shows which loopback is currently running.
• dsl show pattern: Shows what PRBS pattern is currently running.
The following commands display the current DSL error
monitor configuration:
• dsl show errmon maxint: Shows the maximum errors allowed in an
interval before it is considered errored.
• dsl show errmon inttime: Shows the length in seconds of
each interval.
• dsl show errmon intcnt: Shows the number of errored intervals
allowed before restarting.
• dsl show errmon totint: Shows the number of intervals to monitor
before disabling the error monitor.
• dsl show errmon startdelay: Shows the length in seconds to wait
after the DSL link comes up before starting the error monitor.
Changing the data rate (system set timeslots), the clock mode (system
set clockmode), the Annex (dsl set annex), or Line Probe (dsl set
lineprobe), or the DSL error monitor settings will not take effect on the
DSL link until the link restarts. The dsl start command restarts the
DSL link.
DSL Status Commands
The following commands display DSL status:
• dsl show status: Shows the following DSL status information: link
state, sync state, link speed, error counters, line condition, and noise
margin.
• dsl show linkstate: Shows the state of the DSL link: idle, success,
deactivated, or in progress.