Filter
Top Products
10 C698M-A (6/04)
CONNECTING DAISY-CHAINED DATA HUBS
Up to four data hubs can be daisy-chained together. Connect the DVR/HUB OUT port of the next
data hub in the daisy chain (farther from the DX2000 DVR) to the HUB IN port on the data hub being
installed. Use straight-pinned Cat5 cable with RJ-45 connectors. (Refer to Figure 7.)
CONNECTING TO THE DX2000 DVR
Connect the DVR/HUB OUT port of the data hub to the DATA PORT input connector on the DX2000
DVR (you can use either port 3 or 4). Use straight-pinned Cat5 cable with RJ-45 connectors.
CONNECTING POWER TO THE DATA HUB
U.S. Standard
1. Connect the U.S. standard (120V, 60 Hz) power supply’s output connector to the data hub’s
power connector.
2. Plug the power supply into the proper power source.
European Standard
1. Connect the power cord to the European standard (230V, 50 Hz) power supply.
2. Connect the power supply’s output connector to the data hub’s power connector.
3. Plug the power cord into the proper power source.