Filter
Top Products
12 C698M-A (6/04)
4. On the Data Port Configuration tab screen, set up the DX2000 Data Hub. (Refer to the examples
in the
Installation and Programming Examples
section.)
You can select any of the seven ports on Hubs 1, 2, 3, and 4 as you wish. Multiple devices may
be assigned to the same port only if it is an ATM network connection. Non-network devices
may not be assigned to the same port.
To configure your data hub(s), do the following:
a. Use the pull-down menu to select Communication Type.
b. Enter a name for the data device in the Device Name box or accept the default.
c. Checkmark an Enable box to activate the data device.
d. Use the pull-down menu under DVR Port to select either P3Hub or P4Hub as the port on
the DVR to which the data hub will be connected.
e. Use the pull-down menu under Hub to select hub 1-4.
f. Use the pull-down menu under Hub Port to select port 1-7 on the data hub.
g. For ATM network connections, enter then hexadecimal device address in the Network
Address box.
h. Repeat steps a-g for each data device you want to assign.
5. Click the Save button to save this setup.