Filter
Top Products
IPv6 Commands
23 IOLAN DS1/TS2 CLI Reference Guide, Version 4.3
IPv6 Commands
Set IPv6
Description Configures the basic IPv6 settings.
User Level Admin
Syntax
Options dhcpv6-settings
ivp6-address
network-prefix
enable-ipv6-addressing
obtain-using auto-ipv6|dhcpv6
z auto-ipv6—When enabled, the IOLAN will send out a Router Solicitation
message. If a Router Advertisement message is received, the IOLAN will configure
the IPv6 address(es) and configuration parameters based on the information
contained in the advertisement. If no Router Advertisement message is received,
the IOLAN will attempt to connect to a DHCPv6 server to obtain IPv6 addresses
and other configuration parameters. This is the default.
z dhcpv6—When enabled, requests IPv6 address(es) and configuration information
from the DHCPv6 server.
Show IPv6
Description Shows the IPv6 settings.
User Level Admin
Syntax
set ipv6 [dhcpv6-settings ipv6-address on|off]
[dhcp-settings network-prefix on|off]
Set ipv6 enable-ipv6-addressing on|off
[obtain-using auto-ipv6|dhcpv6]
Determines the types of information that the IOLAN will accept from the DHCPv6
server, IPv6 address(es) and/or network prefix(es).
When enabled, the IOLAN will accept IPv6 address(es) from the DHCPv6 server. This
is
off by default.
When enabled, the IOLAN will accept the network prefix from the DHCPv6 server.
This is
off by default.
When enabled, you can configure the IOLAN to obtain the IPv6 address(es) using IPv6
Autoconfiguration or a DHCPv6 server.
Default: Enabled
show ipv6