Filter
Top Products
33
Configuring Users
line-access
Specifies the user access rights to each IOLAN device line. Options are:
z Read/Write—Users are given read and write access to the line.
z Read In—Users are given access to read only outbound data, data that is going
from the IOLAN to the device.
The
on|off option is only for 1-port models. You can disable line access in 2-port +
models by specifying
0 (zero).
phone-number
The phone number the IOLAN will dial to callback the user (you must have set
Callback to On). Enter the number without spaces.
port
When the User Service is Telnet, this is the target port number. The default value will
change based on the type of
Service selected; the most common known port numbers
are used as the default values.
service
The type of service that the user will use.
sess-timer
The amount of time, in seconds, that the Session Timer will run. Use this timer to
forcibly close a user’s session (connection). When the
Session Timer expires, the
IOLAN will end the connection. The default value is
0 (zero), meaning that the session
timer will not expire (the session is open permanently, or until the user logs out). The
maximum value is 4294967
seconds. The User Session Timer will override the Line
Session Timer, with the exception of reverse Telnet sessions.