Filter
Top Products
41
Line Commands
session strings
Controls the sending of ASCII strings to serial devices at session start and session
termination as follows;
z Send at Start—If configured, this string will be sent to the serial device when the
serial device is detected (i.e. signals come up). The maximum size of this field is
128 bytes/characters.
z Send at End—If configured, this string will be sent to the serial device when the
TCP session on the LAN is terminated. The maximum size of this field is 128
bytes/characters
z Delay after Send—If configured, will inset a delay( in milliseconds) after the
string is sent to the device. This delay can be used to provide the serial device with
time to process the string before the session is initiated or terminated.
Default: 10 ms
sess-timer
Enter a time, in seconds, for which the Session Timer will run. Use this timer to
forcibly close the session (connection). When the
Session Timer expires, the IOLAN
will end the connection. The default value is
0 seconds so the port will never timeout.
The maximum value is 4294967 seconds (about 49 days).
stop-bits
Specifies the number of stop bits that follow a byte.
term-type
Specifies the type of terminal connected to the line:
z Dumb
z WYSE60
z VT100
z ANSI
z TVI925
z IBM3151TE
z VT320 (specifically supporting VT320-7)
z HP700 (specifically supporting HP700/44)
z Term1, Term2, Term3 (user defined terminals)
user
For DSLogin line service, makes this a line that is dedicated to the specified user. Only
this user will be able to log in on this line and they won’t need to enter their login name
- just their password.
discard-characters-in-error
When enabled, the IOLAN will discard characters received with a parity or framing
error.
Default: Disabled.