Filter
Top Products
57
Packet Forwarding Commands
Show Packet-Forwarding Line
Description Shows the packet-forwarding settings for the line.
User Level Admin
Syntax
force-transmit-timer
When the specified amount of time, in milliseconds, elapses after the first character is
received from the serial port, the packet is transmitted. After a packet is transmitted, the
next character received starts the timer again. A value of zero (0) ignores this
parameter. Valid values are 0-65535 ms. The default is 0.
forwarding-rule
Determines what is included in the Frame (based on the EOF1 or EOF1/EOF2) or
Packet (based on Trigger1 or Trigger1/Trigger2). Choose one of the following options:
z Strip-Trigger—Strips out the EOF1, EOF1/EOF2, Trigger1, or Trigger1/Trigger2,
depending on your settings.
z Trigger—Includes the EOF1, EOF1/EOF2, Trigger1, or Trigger1/Trigger2,
depending on your settings.
z Trigger+1—Includes the EOF1, EOF1/EOF2, Trigger1, or Trigger1/Trigger2,
depending on your settings, plus the first byte that follows the trigger.
z Trigger+2—Includes the EOF1, EOF1/EOF2, Trigger1, or Trigger1/Trigger2,
depending on your settings, plus the next two bytes received after the trigger.
idle-timer
The amount of time, in milliseconds, that must elapse between characters before the
packet is transmitted to the network. A value of zero (0) ignores this parameter. Valid
values are 0-65535 ms. The default is 0.
packet-size
The number of byte that must be received from the serial port before the packet is
transmitted to the network. A value of zero (0) ignores this parameter. Valid values are
0-1024 bytes. The default is 0.
sof1
When enabled, the Start of Frame character defines the first character of the frame, any
character(s) received before the Start of Frame character is ignored. Valid values are in
hex 0-FF. The default is 0.
sof2
When enabled, creates a sequence of characters that must be received to create the start
of the frame (if the SOF1 character is not immediately followed by the SOF2 character,
the IOLAN waits for another SOF1 character to start the SOF1/SOF2 character
sequence). Valid values are in hex 0-FF. The default is 0.
start-frame-transmit
When enabled, the SOF1 or SOF1/SOF2 characters will be transmitted with the frame.
If not enabled, the SOF1 or SOF1/SOF2 characters will be stripped from the
transmission.
show packet-forwarding line [<number>]