Filter
Top Products
The Canadian Department of Communications label identifies certified equipment. This certification
means that the equipment meets certain telecommunications network protective, operational, and
safety requirements. The department does not guarantee the equipment will operate to the user’s
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facili-
ties of the local telecommunications company. The equipment must be installed using an acceptable
method of connection. In some cases, the company’s inside wiring associated with a single line indi-
vidual service may be extended by means of a certified connector assembly (telephone extension
cord). The customer should be aware that compliance with the above condition may not prevent
degradation of service in some situations.
Repairs to some certified equipment should be made by an authorized maintenance facility designated
by the supplier. Any repairs or alterations made by the user to this equipment, or any equipment
malfunctions, may give the telecommunications company cause to request the user to disconnect
the equipment.
Users should ensure for their own protection that the ground connections of the power utility, tele-
phone lines, and internal metallic water pipe system are connected together. This precaution may
be important particularly in rural areas.
CAUTION: Users should not attempt to make such connections themselves but should contact the
appropriate electrical inspection authority or electrician as appropriate.
The RINGER EQUIVALENCE NUMBER (REN) assigned to each terminal device denotes the percent-
age of the total load to be connected to a telephone loop which is used by the device to prevent
overloading. The termination on a loop may consist of any combination of devices subject only to
the requirement that the total of the REN of all devices does not exceed five.
The REN for the MAT960 is 0.9B.
5
Canadian Ringer Equivalence Number Notice