Filter
Top Products
DM800i™ Series Digital Mailing System Operating Guide
SV61162 Rev. D 9 - 13
10. Grasp the printhead
stand-off and lift the print-
head up and out.
11. Discard the old printhead.
12. Locate the new print-
head. Remove the
orange p
acking tab from
the new printhead as
shown here.
13. Install the new printhead
in the p
rinthead slot.
14. Close the printhead cover and push the prinhead tab back into place.
15. Close the main cover; the “Initializing Printhead” screen appears
16. Once the initializing is complete, the “Print Test Pattern” screen opens
and prompt
s you to “Press Tape or print an envelope”.
You must perform the print test at this time. Follow the prompts, or refer
to Printing
a Test Pattern in this chapter for more information.
17. Proceed to Changing the
Wiper Blade Assembly section.