Filter
Top Products
1 • Read This First
1 - 6 SV61162 Rev. D
• Avoid using wall outlets that are controlled by wall switches, or shared
with other equipment.
• Do not route the power cord over sharp edges or trapped between fur-
niture.
• Ensure there is no strain on the power cord where it becomes jammed
betwe
en the equipment, walls or furniture.
• Be certain the area in front of the wall receptacle into which the
machine is plugged is
free from obstruction.
• To prevent overheating, do not cover the vent openings.
• Read all instructions before attempting to operate the equipment.
• Use this equipment only for its intended purpose.
If your stacker has an AC adapter to power the stacker:
• Use only the AC adapter designed specifically for the stacker and
shown in
Ch
apter 11, Supplies and Options. Third-party AC adapters
may damage the stacker.
• To protect against electrical shock, plug the AC adapter power cord into
a pr
operly grounded wall outlet.
Do not route the AC adapter cable over sharp edges or trap it between
furniture.
Y
our DM Series™ Digital Mailing System is design
ed to
remain powered on
at all times. This is necessary so that the printer station can perform the
required maintenance it needs to maintain peak performance.
Your DM Series™ System has a power switch (for the location, refer to
Chapter 2, p
age 2-6) so that you can properly remove power to the system.
If you need to power off your system, you must use the power switch.
Whe
n yo
u power off the system, the system immediately moves the print-
head back to the capping station to keep the printhead from drying out.
Powering off your system by any other means, such a
s a wall switch, a
power strip, or unplugging from a wall outlet, will result in higher than nor-
mal ink consumption and could damage your mailing system.
NOTE: Always follow the specific occupational safety and health standards
for your workplace.
Important Information About Powering Your
DM Series™ Digital Mailing System Off
NO
NO
YES
OFF
ON