Filter
Top Products
DM800i™Series Digital Mailing System Operating Guide
SV61162 Rev. D 3-3
4. Place the stack of mail on the feed deck shown in the picture below.
• Place the envelopes with the flaps down and against the rear
wall.
• Make sure the envelopes are pushed far enough so that they
cover the fee
d sensor on the rear wall.
5. Adjust the side guide so it is close to, but not touching, the bottom edge
of the envelo
pe stack. Be sure and leave a slight clearance between
the side guide and envelopes (about 1/16 inch clearance).
6. Adjust the thickness adjustment knob to
adjust for envelo
pe thickness. For
thicker pieces of mail (3/8” to 5/8”), or
mail containing several inserts, use the
thick mail setting. For mail containing
only single inserts, or for postcards, use
the normal mail setting. Refer to the fig-
ure on the right.
To pick a setting, turn the knob to the
arrow loca
ted on the feed cover.
7. Make sure you have sufficient funds in
your postage meter
. If the message
“Low Funds” appears on the screen,
make sure you can complete the mail
run with the funds you have. If you do
not have enough funds, see Chapter 6,
Adding Postage in this guide. uide and
envelopes (about 1/16 inch clearance).
Running the
Mail
1. Press the Mode key on the IntelliLink® Control Center.
2. Select Key In Post
age.
3. Key in the correct postage value using the numeric keys on the control
center,
then press the Enter key.
4. Place the piece of mail on the feed deck and press the Sta
rt key.
Feed
Sensor
Side Guide
Thin Mail Setting
Thick Mail Setting