Filter
Top Products
Content Security Gateway User’s Manual
Default Gateway: This will be the Gateway IP address.
Domain Name Server (DNS): This is the IP Address of the DNS server.
For PPTP (European User Only): This is mainly used in Europe. You need to know the PPTP Server
address as well as your name and password.
User Name: The user name is provided by ISP.
Password: The password is provided by ISP.
IP Address: Enter the static IP address assigned to you by your ISP, or obtain an IP address
automatically from ISP.
PPTP Gateway: Enter the PPTP server IP address assigned to you by your ISP.
Connect ID: This is the ID given by ISP. This is optional.
BEZEQ-ISRAEL: Select this item if you are using the service provided by BEZEQ in Israel.
Service-On-Demand: The PPPoE connection will automatically disconnect after a length of idle time
(no activities). Enter in the amount of idle minutes before disconnection. Enter ‘0’ if you do not want the
PPPoE connection to disconnect at all.
Ping: Select this to allow the WAN network to ping the IP Address of the Content Security Gateway. This will
allow people from the Internet to be able to ping the Content Security Gateway. If set to enable, the device will
respond to echo request packets from the WAN network.
WebUI: Select this to allow the device WEBUI to be accessed from the WAN network. This will allow the
WebUI to be configured from a user on the Internet. Keep in mind that the device always requires a username
and password to enter the WebUI.
3.3 Configure DMZ interface
Depends on your network requirement, you can disable the DMZ port, make DMZ port transparent to WAN or
enable NAT function on it.
To configure the DMZ port, select the Interface tab on the left menu, then click on DMZ, the following page is
shown.
3.4 Configure Policy
STEP 1:
Click on the Policy tab from the main function menu, and then click on Outgoing (LAN to WAN) from the
sub-function list.
STEP 2:
Click on New Entry button.
STEP 3:
When the New Entry option appears, enter the following configuration:
Source Address – select “Inside_Any”
- 9 -