Filter
Top Products
Content Security Gateway User’s Manual
Destination Address – select “Outside_Any”
Service - select “ANY”
Action - select “Permit”
Click on OK to apply the changes.
STEP 4:
The configuration is successful when the screen below is displayed.
Please make sure that all the computers that are connected to the LAN port have their Default Gateway IP
Address set to the Content Security Gateway’s LAN IP Address (i.e. 192.168.1.1). At this point, all the
computers on the LAN network should gain access to the Internet immediately. If a Content Security Gateway
filter function is required, please refer to the Policy section in chapter 4.
- 10 -