Filter
Top Products
2. Connect LAN Cable
Use the supplied LAN cable to connect the LAN port on the IAD-200 / IAD-200W to
your hub.
3. Connect ADSL Cable
Connect the supplied ADSL cable from the ADSL port on the IAD-200 / IAD-200W to
the ADSL terminator provided by your phone company.
4. Connect PSTN Line
Connect the PSTN socket on the rear of the IAD-200 / IAD-200W to your normal phone
line socket.
5. Connect Phone
Connect a standard phone to the Phone socket on the rear of the IAD-200 / IAD-200W.
6. Power Up
Connect the supplied power adapter to the IAD-200 / IAD-200W. Use only the power
adapter provided. Using a different one may cause hardware damage.
Power up by pressing the rear-mounted power switch IN, and wait for startup to be com-
pleted.
7. Check the LEDs
• The Power LED should be ON.
• The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
• Either the 100BT or 10BT LED should be ON.
• Phone LED should be OFF.
• PSTN LED will be OFF.
• WLAN LED should be ON (IAD-200W only).
• ADSL LED should be ON.
• Internet LED will be OFF.
It will come ON when configuration is complete and correct, and an Internet connec-
tion is established.
For more information, refer to Front-mounted LEDs in Chapter 1.
9