Filter
Top Products
Wireless Station Configuration (IAD-200W only)
This section applies to all Wireless stations wishing to use the IAD-200W's Access Point,
regardless of the operating system which is used on the client.
To use the Wireless Access Point in the IAD-200W, each Wireless Station must have compati-
ble settings, as follows:
Mode
The mode must be set to Infrastructure (rather than Ad-hoc)
Access points only operate in Infrastructure mode.
SSID (ESSID)
This must match the value used on the IAD-200W. The default value is
Wireless.
Note! The SSID is case sensitive.
Wireless
Security
By default, Wireless security on the IAD-200W is disabled.
• If Wireless security remains disabled on the IAD-200W, all stations
must have wireless security disabled.
• If Wireless security is enabled on the Wireless VoIP Gateway
(either WEP or WPA-PSK), each station must use the same settings
as the Wireless ADLS VoIP Gateway.
Wireless Configuration on Windows XP (IAD-200W only)
If using Windows XP to configure the Wireless interface on your PC, the configuration proce-
dure is as follows:
1. Open the Network Connections folder. (Start - Settings - Network Connections).
Figure 25: Network Connections (Windows XP)
2. Right-click the Wireless Network Connection, check that it is enabled (menu option says
Disable, rather than Enable) and then select View Available Wireless Networks.
3. You will then see a list of wireless networks.
37