Filter
Top Products
VRT-401 User Manual
14
LAN Screen
Use the LAN link on the main menu to reach the LAN screen An example screen is
shown below.
Figure 7: LAN Screen
Data - LAN Screen
TCP/IP
IP Address
IP address for VRT-401, as seen from the local LAN. Use the
default value unless the address is already in use or your LAN is
using a different IP address range. In the latter case, enter an
unused IP Address from within the range used by your LAN.
Subnet Mask
The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which VRT-401 is attached (the same value as the
PCs on that LAN segment).
DHCP Server
• If Enabled, VRT-401 will allocate IP Addresses to PCs
(DHCP clients) on your LAN when they start up. The default
(and recommended) value is Enabled.
• If you are already using a DHCP Server, this setting must be
Disabled, and the existing DHCP server must be re-
configured to treat VRT-401 as the default Gateway. See the
following section for further details.
• The Start IP Address and Finish IP Address fields set the
values used by the DHCP server when allocating IP Ad-
dresses to DHCP clients. This range also determines the
number of DHCP clients supported.
See the following section for further details on using DHCP.
Buttons
Save
Save the data on screen.
Cancel
The "Cancel" button will discard any data you have entered and
reload the file from VRT-401.