Filter
Top Products
VRT-401 User Manual
42
Figure 27: Special Applications Screen
Data - Special Applications Screen
Checkbox
Use this to Enable or Disable this Special Application as required.
Name
Enter a descriptive name to identify this Special Application.
Incoming
Ports
• Type - Select the protocol (TCP or UDP) used when you receive
data from the special application or service. (Note: Some applica-
tions use different protocols for outgoing and incoming data).
• Start - Enter the beginning of the range of port numbers used by
the application server, for data you receive. If the application uses
a single port number, enter it in both the "Start" and "Finish"
fields.
• Finish - Enter the end of the range of port numbers used by the
application server, for data you receive.
Outgoing
Ports
• Type - Select the protocol (TCP or UDP) used when you send
data to the remote system or service.
• Start - Enter the beginning of the range of port numbers used by
the application server, for data you send to it. If the application
uses a single port number, enter it in both the "Start" and "Finish"
fields.
• Finish - Enter the end of the range of port numbers used by the
application server, for data you send to it. If the application uses a
single port number, enter it in both the "Start" and "Finish" fields.
Using a Special Application
• Configure the Special Applications screen as required.
• On your PC, use the application normally. Remember that only one (1) PC can use
each Special application at any time. Also, when 1 PC is finished using a particular
Special Application, there may need to be a "Time-out" before another PC can use
the same Special Application. The "Time-out" period may be up to 3 minutes.