Filter
Top Products
E-32
General Operation
If the password input display appears when the power is turned on
When a password has been registered, the “Password” input window appears on the projected image when the power is turned
on. The projector continues projecting this image until the correct password is input. At this time, only the POWER/STANDBY
button (power off) works. Use the procedure described below to input the registered password. For instructions on registering the
password, see E-31.
Register using the (four) input buttons.
Be sure to input the registered 4-digit number.
Example: To input the password “3221”
When input button “ECO” is pressed, an “
*
” (asterisk) is entered for the first digit.
Continuing, pressing the “MUTE” “MUTE” “FREEZE” input buttons will enter as-
terisks in the remainder of the four digits.
If the password matches, the window turns off and the projector can be used
normally.
Canceling the password/Changing the password
The password is canceled and changed using the menus. For instructions on operating the menus, see “Menu Operation Method”
on E-34.
Canceling the password
Select “Security Lock” in the “Option” menu and set it to “Disable”.
This clears the password and disables the security lock.
The password input display no longer appears when the power is turned on.
Changing the password
After setting “Security Lock” to “Disable” as described above, set it back to “En-
able”. The menu closes and the password registration display appears.
Register the new password. See “Registering the password” on E-31.
[Password input window]