Filter
Top Products
E-55
When an Indicator is Lit or Flashing
S
O
U
R
C
E
K
E
Y
S
T
O
A
U
T
K
E
Y
S
T
O
N
E
POWER
UIC
K MENU
STANDBY
STATUS
MENU
The indicators on the projector’s control panel light or flash to
notify of problems, as described below.
An indicator is also used to notify you of the currently set power
mode. See “Power Cable Connections and Switching the Power
On/Off” on page E-21.
What you should do
It is time to replace the lamp.
Replace with a new lamp cartridge.
The lamp has reached the end of its service life. The power
will no longer turn on.
The projector can be used for 100 hours after the lamp has reached
the end of its service life.
Replace with a new lamp cartridge.
The lamp cover is open.
The lamp cover is not properly mounted. Mount it properly.
The temperature is abnormally high.
• The temperature protector has been activated. If the room tem-
perature is high, move the projector to a cool place. If the
projector’s internal temperature is high, check the cooling fan’s
ventilation slots and clean them if they are clogged.
• When the temperature protector is activated, the power turns
off and in some cases will not turn back on immediately. In this
case wait about 90 seconds, then try again.
The fan has stopped.
Unplug the power cable and contact a store that sells the KG-
PS100S/KG-PS120X/KG-PS125X for repairs.
The lamp will not light.
Wait at least 90 seconds, then turn the power back on. If the prob-
lem persists, unplug the power cable and contact a store that sells
the KG-PS100S/KG-PS120X/KG-PS125X for repairs.
Should an indicator be in a condition other than normal or flash at a rate other than the aforementioned, disconnect the power
cable and contact your store of purchase.
Thermal Protector
If the temperature within the projector becomes abnormally high, the thermal protector will be activated and will switch off the
power of the projector.
Should this happen, please take the following actions.
1. Switch off the power and disconnect the power plug from the wall outlet.
2. Check the following matters and take the required measures.
When the projector is being used in a location that has a high ambient temperature, set it up again in a cool location. Check the
outflow and intake holes and clean them if they are obstructed.
3. Wait about 60 minutes until the temperature of the projector drops.
If after having performed the above matters, the problem still has not been solved, please contact your store of purchase.
STANDBY
indicator
POWER
indicator
STATUS
indicator
POWER
STANDBY STATUS
POWER
STANDBY STATUS
POWER
STANDBY STATUS
POWER
STANDBY STATUS
When the power is on (Lit green)
Lit red
Standby mode (Lit green)
Blinks red
(1 second on/1 second off)
Lit green
Blinks red
(0.5 seconds on/0.5 seconds off)
Lit green
Lit green
Blinks red
(0.5 seconds on/0.5 seconds off)
Lit green
POWER
STANDBY STATUS
Lit red
Blinks green for 60 seconds (then,
lit green)
Indicator status
POWER
STANDBY STATUS
Blinks red quickly
(0.1 seconds on/0.1 seconds off)
Lit green