Filter
Top Products
Communication
13-2
Powerware
®
9390 UPS (40–80 kVA) Installation and Operation Manual S 164201535 Rev C
Relay Interface Card
Modem Card
Modbus C ard
ConnectUPS-X Web/SNMP Card
Hot Sync CAN Bridge Card
Industrial Relay Card
Figure13-1.OptionalX-SlotCards
13.2 LanSafe Power Management Software
Each Powerware 9390 UPS ships with LanSafe Power Management Software. To begin
installing LanSafe software, see the instructions accompanying the Powerware Software
Suite CD.
LanSafe software uses an RS-232 serial link to communicate with the UPS. The software
provides up-to-date graphics of UPS power and system data and power flow, a complete
record of critical power events, and notification o f important UPS or power information.
With custom views for monitoring status and metering information, various user groups
can select the most useful view for their specific needs.
13.3 Remote Notification
For connection and setup of a modem, or to enable Remote N otify and Call Home features
within the UPS, please contact Powerware (see page 1-6).
Remote Notification provides the UPS with the capability to use a standard off-the-shelf PC
modem as a telephone interface. The features provided by this option are as follows:
Ī Call a remote terminal or pager based on programmable events and alarms.
Ī Four separate, programmable notification groups (phone numbers).
Ī Automatic answering (user-configurable) for access to the Terminal mode of the UPS.
Ī Remote and local ability to clear Call Out alarms and events.
Ī Error detection and correction for misconfigured and disconnected modems.
Remote Notification provides the user with the option of receiving alarms and notices at a
remote location. Using the Terminal mode, the user calls the UPS to perform basic
monitoring. In the event of a UPS alarm or notice, the user is notified at the remote
location. The UPS calls through the modem to the user’s computer or pager and leaves a
message.
Remote Notification is an extension of the Terminal mode with the additional support
algorithms necessary to control an external modem. Connection to the UPS is made when
ausercallstheUPSonthephone.Theuserhasexactlythesamecapabilitiesasifusinga
terminal connected directly to an RS-232 port.