Filter
Top Products
29
Powerware
®
5115 Rack-Mount User’s Guide : 164201449 RevA www.powerware.com
CHAPTER 4
OPERATION
This section describes:
: Turning the UPS on and off
: Starting the UPS on battery
: Standby m ode
: The UPS front panel and indicators
: Initiating the self-test
Turning the UPS On
After the UPS is connected to a power outlet, the UPS enters Standby
mode. To turn on the UPS, press and hold the
button until you hear
the UPS beep (approximately two seconds). After the UPS is turned on,
it conducts a self-test and enters Normal mode. The
,Load1,and
Load 2 indicators illuminate indicating that power is available from the
UPS output receptacles.
Starting the UPS on Battery
NOTE TheUPS does not auto-detect the input frequency when starting on battery; the
default is the last frequency used by the UPS.
To turn on the UPS without using utility power, press and hold the
button for two seconds. The UPS supplies power to your equipment
and goes into Battery mode.
Turning the UPS Off
To turn off the UPS, press and hold the button for two seconds and
then unplug the UPS from the power outlet. If you do not unplug the
UPS, it remains in Standby mode.