Filter
Top Products
31
Powerware
®
5115 Rack-Mount User’s Guide : 164201449 RevA www.powerware.com
CHAPTER 5
ADDITIONAL UPS FEATURES
This section describes:
: Changing the voltage configuration
: The Netw ork Transient Protector
: Load segments
Voltage Configuration
The DIP switches on the UPS rear panel (see Figure 14) are used to
configure the output voltage and input voltage range.
1. The UPS must be completely shutdown.
To turn off the UPS, press and hold the
button for two
seconds and then unplug the UPS from the power outlet.
2. Set the DIP switches according to t he configurations in Table 1.
3. Plug the UPS into a power outlet.
4. Press and hold the
button until you hear the UPS beep
(approximately two seconds) to turn the UPS on.
OFF
ON
UPS Rear Panel
21
Figure 14. DIP Switches