Filter
Top Products
page 17
Maintenance and Troubleshooting
The 719e climber requires very little maintenance. The only maintenance you
need to do periodically is to clean the climber. You will also need to change the
batteries when they wear down. Instructions for these procedures are provided
in this section.
If you encounter problems with the 719e climber, refer to
Troubleshooting Tips
in this section for help.
Cleaning the 719e Climber
Clean the 719e climber periodically with mild soap and water or a general
household cleaner. Wipe the surface of the electronic console with a damp
sponge or soft cloth. Dry with a clean towel.
Do not pour or spray liquids on the
electronic console.
Changing the Batteries
The 719e climber comes with two “AA” alkaline batteries installed. When your
electronic console no longer shows a digital readout or the count becomes
erratic, you need to change the batteries.
To change the batteries:
1. Press down on the latch to open the door on the side of the electronic
console and replace the old batteries with two new “AA” alkaline batteries.
The entire display lights up momentarily, the console beeps twice, and then
the display shows “002.”
2. Press the MODE key once. The display shows “001.”
NOTE: If you happen to press the MODE key more than once, do not worry.
You can scroll through all the options on the display by pressing MODE
repeatedly until “001” appears. Pressing START/STOP backs up the display
one option.
3. Press RESET to activate the climber.
4. If you have not already done so, close the door on the side of the electronic
console display. You can now work out on the climber.