Filter
Top Products
page 9
10. Tighten Handrail Clamp. (Diagram 7) Look underneath the upper handrail
clamp and check to see that the handrail ends meet in the middle of the
clamp. If necessary, realign the handrails and then, tighten the handrail
clamps using the hex key (H) provided.
Tighten the bolts securely
.
Note: The black foam wrap on the handrails should be snug up against the
handrail clamps.
Diagram 8
Install electronic console display
11. Install Electronic Display on Upright Support. (Diagram 8) Take the
following steps to install the electronic console display:
a. Remove the tape from the reed switch cable on the handrail console.
b. Align the tab on the connector plug with its receptacle on the back of
the electronic console display. Gently push the plug into its receptacle.
c. Feed the excess cable back through the hole and into the upright
support.
d. Place the electronic console display on the handrail console and align
the screw holes.
Important: Be careful not to trap or pinch the reed switch cable.
e. Attach the electronic console display to the handrail console using the
two screws (F). Insert the screws from the back of the console as
shown in Diagram 8.
12. Set Resistance Level. Set the resistance level by turning the adjustment
knob at the top of the resistance cylinder to a middle (4, 5, or 6) setting.
Once you have used the climber and are familiar with it, set the resistance
to a comfortable level. For this procedure, see
Setting the Resistance Level
in the next section.
Phillips head screwdriver
Electronic console display
Upper handrail clamp
Upper handrail console
Upright support (long tube)
Screw mounts