Filter
Top Products
page 6
Assembling the 719e Independent Action Climber
Follow the instructions in this section to assemble the 719e Independent Action
Climber.
It is important to read through the entire procedure before assembling
your climber.
To assemble the 719e climber:
1. Prepare Upper Frame for Assembly. Carefully unpack the parts of the
719e climber and open the hardware kit.
Note: For the following steps, hardware callouts are identified by a letter in
parentheses. To be sure you are using the correct part, refer to Diagram 2.
Diagram 3
Place frame on base.
Upright support
(Long tube)
Lower handrail clamp
Reed switch cable
Base column support
(Short tube)
2. Align Upper Frame Pieces. (Diagram 3) Use the lower console clamp and
remove two large, black metal washers (C) and two of the frame-to-frame
bolts (E) from the hardware kit. Ask for assistance to align the bolt holes in
the long tube with the matching holes in the short tube.
3. Prepare the lower console clamp. (Diagram 3) Place the lower handrail
clamp into position. Align the holes on the lower handrail clamp between
the long and short tubes.
Important: As you assemble the climber, be careful not to pinch the reed
switch cable that runs through the long tube.
4. Secure Upper Frame Together. (Diagram 3) Place one washer (C) onto
each of the two frame-to-frame bolts (E) and insert the bolts through the
aligned holes on the frame. Thread the bolts through the lower handrail
clamp and into the short tube. Fully tighten the bolts.
Lower handrail console
Bolt pad