Filter
Top Products
page 8
Diagram 6
Connect resistance cylinders to
frame.
Plastic collar
Upper axle
Plastic bushing
Washer
Resistance cylinder
Upright support (long tube)
8. Install Upper Handrail Console. (Diagram 7) Position the upper handrail
console on top of the long tube. Pull the excess reed switch cable up
through the large hole in the handrail console and tape it to the top of the
console. Locate two button-head bolts (D) in the hardware kit and place a
small, black washer (B) on each bolt. Secure the handrail console to the
frame by inserting the bolts and washers through the top of the handrail
console and into the upright support.
9. Install Handrails. (Diagram 7) Loosen the bolts in the handrail clamps
using the hex key provided. Orient the handrails so that the longer,
“straight” section of the handrails is positioned on top. Place the handrails
in the upper clamp. Rotate the lower portion of the handrails into position
and insert each handrail into the lower clamp. Finger-tighten the bolts into
both clamps.
Lower handrail clamp
Diagram 7
Install handrail console and
insert handrails into clamps
Upper handrail clamp
Upper handrail console
Electronic console mounts
Handrail (long, straight section)
Upright support (long tube)
7. Connect Resistance Cylinders to Upright Support. (Diagram 6) Slide the
plastic collar (G) over the upper axle, with the straight bevel toward the
frame. Lift up on the stair arm until you can push the top of the resistance
cylinder onto the upper axle, then attach the cylinder to the axle using a
bushing (L), washer (C), and button-head bolt (D). Repeat step 7 for the
other resistance cylinder.