Filter
Top Products
USING THE OPTIONAL SETUP MODULE
94
the printer, the Setup information in the printer’s memory may not have
been changed. In this case the printer will power up normally and no
message will be displayed.
Using the Setup Module to
Copy Setup Data From One Printer to Another
This use of the Setup Module is beneficial when installing or updating
several printers that need to be configured exactly the same. To do this,
you will need to perform the installation procedure once for each printer.
First, install the Setup Module on the printer where the Setup data is to be
copied from. If the printer determines that steps 8 and 9 are required,
choose “Copy to Module” in step 9 and allow the printer’s power up
procedures to complete. If any additional changes need to be made to the
configuration of this printer, enter Setup and make them before removing
the Setup Module. Any changes made will automatically be stored both in
the printer’s internal memory and the Setup Module.
You may now power off the printer and remove the Setup Module.
Remember to reconnect the serial cable if one was attached.
Now perform the installation procedure on each of the printers that are to
be configured the same as the first. In step 9 be sure to choose “Copy to
Printer”. After the Setup Module is removed, remember to reconnect the
serial cable if one was attached.
Note: Setup modules for Printek FormsMaster 8000se Series
printers and PrintMaster 850 Series printers are not
interchangeable. Data backup will not take place if the
modules are used on the wrong printer.