Filter
Top Products
GETTING STARTED
17
3. Lift open the paper door on the front of the printer to expose the
paper feed tractors as shown in the following picture.
FormsMaster 8003se Tractors
Loading the Front Tractors
4. Open the doors on each tractor.
5. Feed the paper up through the bottom of the printer and position the
holes in the edge of the paper over the pins in the left tractor while
making sure that the paper will not extend above the top of the
tractors. Then close the tractor door.
Note: The left tractor position is not adjustable. If it is necessary
to adjust where printing begins, refer to “Aligning Print”
in the “DAILY OPERATION” section of this manual.
6. Now position the paper in the right tractor in the same fashion. If
necessary, the position of the right tractor may be adjusted. To do
so, move the lever on the side of the tractor down to unlock the
tractor and slide the tractor sideways on the shafts. If necessary, the
paper guides between the tractors may be slid in either direction to
accommodate the form width. Make sure that the guides are spaced
evenly between the tractors.