Filter
Top Products
DAILY OPERATION
28
case of the FormsMaster 8003se this will also move the shuttle
forward for easy access to all tractor paths.
3. Continue to press the FORM SELECT button until the desired form
name is shown on the top line of the display. The form name will be
FORM 0 through FORM 9 or the actual name of the form if the
name has been set in Setup. If the desired form is not considered to
be “loaded” by the printer, <Not Loaded> will flash on the
bottom line of the display. In the case of the FormsMaster 8003se
the not loaded message will alternate with the path(s) that this form is
to be loaded in.
Loading the Form in the Tractors
4. Open the paper door on the front of the printer. This will provide
access to the tractors as shown below. If your printer is a
FormsMaster 8000se, only one set of tractors will be available and
you may skip ahead to step 6.
FormsMaster 8003se tractors
5. Depending upon which path(s) the new form is to be placed in, you
may need to tilt the front and/or center tractors forward as shown.