Filter
Top Products
Using the PT2000 and TopGun with PALPRO
22 PT2000™ & TopGun™
2. Attach the other end to the 25-pin connector of the keyboard
wedge cable (refer to
Figure 3-6 on page 21).
3. PC: Attach the small male plug of the PSC cable to the keyboard
jack on the PC (refer to
Figure 3-6).
Ter min al: Insert the keyboard cable plug into the modular jack
on the PSC cable connector.
4. PC: Attach the keyboard cable to the small female jack on the
PSC cable (refer to
Figure 3-6).
Ter min al: Insert the modular plug of the PSC cable into the
keyboard input jack on the terminal.
5. Scan the appropriate bar code below:
Using the
Keyboard
Wedge
To use the PT2000 or TopGun as a keyboard wedge, complete the setup
and installation procedures described earlier in this chapter. Then
complete the following steps:
1. From the PALPRO Options menu, select <F3>.
Figure 3-7: The PALPRO Options Menu
2.
Open the application and place the cursor at the location where
the data is to be entered.
AT or PS/2 models
30-286, 50, 50Z, 60,
70, 80, 90, 95 (U.S.
keyboard)
*$+$-D2C011EE*
IBM 3151 terminal
*$+$-D2C015EE*
PALPRO OPTIONS
F3=WEDGE
F2=SELECT PROG
F4=PASSWORD
¤
PT2000.book Page 22 Thursday, February 26, 2004 9:34 AM