Filter
Top Products
Getting Started
Release Leve
r
Battery Contacts
Figure 2 - Battery Installation
To charge the battery, connect an optional power supply to the appropriate input source, and then connect the
output of the power supply to the printer’s Power Connector at the location shown in
Figure 3. The Battery
Indicator will turn on and remain on until the battery is fully charged. This may take up to 2½ hours.
Note: You must charge the battery for at least 2½ hours prior to the first use.
Caution: Use only Psion Teklogix power supplies designed specifically for your PrintAbout printer. Using a
different power supply may cause damage to the printer and will not be covered by the printer’s
warranty. Psion Teklogix power supplies are available for use with 100-240VAC/50-60Hz and
for12/24VDC vehicle applications.
Power Connecto
r
Batter
y
Indicato
r
Figure 3 - Power Connector & Battery Indicator
4