Filter
Top Products
A – Fast!UTIL Configuration Settings
FC0151103-00 E A-5
■ Disable Database Load. When enabled, the device database is read from
the Registry during driver initialization. When disabled, the device database
is created dynamically during driver initialization. The default is No.
NOTE: This option usually applies to Windows NT operating environment.
■ IOCB Allocation. This setting specifies the maximum number of buffers
from the firmware’s buffer pool that are allocated to any one port. The default
is 256 buffers.
■ Extended Error Logging. This setting provides additional error and debug
information to the operating system. When enabled, events are logged into
the Windows NT Event Viewer. The default is Disabled.
A.2.6
Extended Firmware Settings
From the Configuration Settings menu in Fast!UTIL, select Extended Firmware
Settings. The default settings for the QLA22xx host adapter board are listed in
table A-3 and described in the following paragraphs.
Table A-3. Extended Firmware Settings
Setting Options Default
Extended Control Block Enabled or Disabled Enabled
RIO Operation Mode 0, 1, 2, 3, 4 0
Connection Options 0, 1, 2, 3 3
Class 2 Service Enabled or Disabled Disabled
ACK0 Enabled or Disabled Disabled
Fibre Channel Tape Support Enabled or Disabled Disabled
Fibre Channel Confirm Enabled or Disabled Disabled
Command Reference Number Enabled or Disabled Disabled
Read Transfer Ready Enabled or Disabled Disabled
Response Timer 0-255 0
Interrupt Delay Timer 0-255 0