5 Server Properties Configuration
The Quatech DSE-410D can be configured in one of three ways:
DSE-410D Manager Software
Telnet Mode
Console mode
The Server Properties Configuration screen shown in the previous chapter displays a
box for each property; Telnet or Console configuration will show similar
configuration items.
In the DSE-410D Manager you can use the mouse to select the property and
parameters for each property. Keyboard keys can be used as listed:
Tab: Move to next configuration property.
Tab+Shift: Move back to previous property.
Left Arrow: Change values or contents of current property or
Move up the list of items for current property
Right Arrow: Change values or contents of current property or
Move down the list of items for current property.
Enter: Select Update or Cancel
The Keyboard keys can be used as listed below for Telnet or Console. The default
Telnet port for Configuration is 23.
There are a few pre-defined keys to move around the menu and to save changes.
Space Bar: To refresh the configuration page.
Tab: To move the cursor to next field.
Back Space: To move the cursor to previous field.
Arrow Keys: To move the cursor around the configuration page.
Enter: Telnet only - To open 2
nd
window of selections, confirm a selected
change, or to activate the save, default, reset, and status.
Note: Using Ping after/before Configuration will check communications with the
selected IP address.
At run prompt enter: Command
Next enter: Ping xxx.xxx.xxx.xxx using the IP address on Command line.
To check your computer IP address, gateway, enter IPCONFIG at prompt.
When done, enter EXIT to return to Windows and close DOS window.
Document Number: 940-0186-100 – DSE-410D Owner’s Manual 23
Quatech, Inc. - 5675 Hudson Industrial Parkway, Hudson, OH 44236 – 330.655.9000
http://www.quatech.com