Filter
Top Products
33
Trunking Operations
codes S-12, S-13, or S-14, these restrictions apply:
• S-12 can only be assigned to Blocks 0, 2, 4, or 6
• S-13 can only be assigned to Blocks 0 and 4
• S-14 can only be assigned to Block 0
Because these size codes require multiple blocks, the
scanner prompts you for the next available block when
you program a fl eet map. For example, if you set Block 0
as S-12, b2 is the next block instead of b1. If you assign
Block 0 as S-14, you would not see another prompt
because S-14 uses all available blocks.
6. Selecte a size code for each desired block.
For Motorolla Type II, instead of selecting the size block,
enter size code S-0.
7. Press SRCH. The scanner searches using the map you
programmed.
programming base and offset frequencies
To properly track Motorola VHF and UHF trunked systems, you
must program the applicable base and offset frequencies for each
system.
1. Select the trunking programming mode.
2. Press the number key of the bank where you want to store the
base frequency.
3. Press or to select Motorola Type II UHF or VHF system, then
press E/PGM.
4. Press or to select bASE, then press E/PGM.
5. Press the confi guration Block Number (1-3) .
6. Press the number keys to enter a new base frequency, then
press E/PGM.
7. Press . The display changes to spacing-frequency entry mode.
NOTE
NOTE