Filter
Top Products
10
Cautions:
You must use a power source that supplies 9V DC
and delivers at least 300 mA. Its center tip must be
set to positive and its plug must fit the scanner's
PWR
jack. Using an adapter that does not meet these speci-
fications could damage the scanner or the adapter.
• Always connect the DC adapter to the scanner before you
connect it to the power source. When you finish, disconnect
the adapter from the power source before you disconnect it
from the scanner.
To power the scanner using a DC adapter, attach the Adapta-
plug adapter to the DC adapter so the tip reads positive (+) and
set the adapter’s voltage switch to 9V. Next, insert the Adapta-
plug adapter into the scanner’s
PWR
jack, then plug the DC
adapter into your vehicle’s cigarette lighter socket.
Note:
If you use a cigarette lighter power cable and your vehi-
cle’s engine is running, you might hear electrical noise from the
engine while scanning. This is normal.
CHARGING RECHARGEABLE BATTERIES
Your scanner has a built-in charging circuit that lets you charge
Ni-Cd rechargeable batteries while they are in the scanner. To
charge rechargeable batteries, simply connect an AC adapter to
the scanner’s
PWR
jack.
Notes:
• You must have installed Ni-Cd rechargeable batteries in the
supplied yellow rechargeable battery holder in order to
charge them while they are in the scanner. If you use Ni-MH
or high-capacity Ni-Cd batteries in your scanner, you must
use an external charger to charge them.
• You cannot use a DC adapter to recharge rechargeable bat-
teries in the scanner due to the limitations of the scanner’s
charging circuit.
It takes between 14 and 16 hours to recharge rechargeable bat-
teries that are fully discharged. You can operate the scanner
while recharging the batteries, but charging takes longer.
!
20-314.fm Page 10 Monday, December 13, 1999 12:55 PM