Radio Shack PRO-79 Scanner User Manual


 
8
PREPARATION
Note:
If the scanner’s display locks up or does not work properly
after you connect a power source, you might need to reset or ini-
tialize the scanner.
Important:
If you have problems, first try to reset the scanner
(see “Resetting the Scanner” on Page 26). If that does not work,
you can initialize the scanner (see “Initializing the Scanner” on
Page 26); however, this clears all information stored in your
scanner’s memory.
INSTALLING BATTERIES
You can power your scanner with four AA batteries (not sup-
plied). For the best performance and longest life, we recom-
mend RadioShack alkaline batteries. Or, you can use
rechargeable nickel-cadmium batteries and charge them either
inside or outside the scanner. Both types of batteries are avail-
able at your local RadioShack store.
Cautions:
Use only fresh batteries of the required size and recom-
mended type.
Do not mix old and new batteries, different types of batteries
(standard, alkaline, or rechargeable), or rechargeable bat-
teries of different capacities.
Follow these steps to install batteries.
1. Slide the battery compartment cover in the
direction of the arrow to remove it.
2. If you are using non-rechargeable batteries,
place them into the supplied black holder,
as indicated by the polarity symbols (+ and
–) marked on the holder. Or, if you are using
rechargeable batteries, place them into the
supplied yellow holder, as indicated by the
polarity symbols (+ and –) marked on the holder.
3. Place the battery holder (with batteries) into the battery
compartment.
4. Replace the cover.
20-314.fm Page 8 Monday, December 13, 1999 12:55 PM