Filter
Top Products
32
2. Press
MON/CL
.
M
, a monitor memory number, and
CH
flash,
and the frequency in the selected monitor memory appears.
3. Enter the desired monitor memory’s number (1–20), then
press
MON/CL
again. The selected monitor memory’s fre-
quency appears.
4. Press
ENT
. The scanner stores the frequency in the selected
channel.
5. To move another monitor memory frequency to the next
channel, press
PGM
and repeat Steps 2–4.
SCANNING THE STORED CHANNELS
To set the scanner to continuously scan through all channels
with stored frequencies, simply press
SCAN
.
SCAN
and
▲
ap-
pear, and the scanner begins to rapidly scan until it finds an ac-
tive frequency.
When the scanner finds an active frequency, it stops and dis-
plays that channel and frequency number, then it automatically
begins scanning again when the transmission on that frequency
ends.
Notes:
• To reverse the scanning direction, press
▲
or
▼
.
• To set the scanner to remain on the current channel for 2
seconds after the transmission ends, see “Delay” on
Page 36.
• To set the scanner to remain on the current channel, even
after the transmission stops, press
MAN
at any time during
the transmission so
MAN
appears and
SCAN
disappears
(see “Monitoring a Stored Channel” on Page 33).
• To lock out channels so the scanner does not stop for a
transmission on those channels, see “Locking Out Channels
or Frequencies” on Page 36.
20-314.fm Page 32 Monday, December 13, 1999 12:55 PM