Filter
Top Products
69
Beyond the Basics
6. To enter additional trunking frequencies as subsequent
channels in the same bank, press PGM or e to access
the next open channel then enter the frequencies. (See
“Storing Known Frequencies into Channels”).
7. Press SCAN to start scanning.
If you enter a frequency that has already been entered,
the scanner sounds an error tone and displays Dupl.
Freq. and the channel number that has been duplicated.
If the dual entry is an error press CL and enter the correct
frequency. If the dual entry is intentional press ENT to
accept.
You may replace any frequency by selecting the bank and
channel, pressing PGM and entering the new frequency.
If you make an error in the entry process, press CL as often as
needed to erase the incorrect data.
programming Motorola trunking systems (UHF-Lo)
You can program the scanner to receive transmissions in
the UHF-Lo band (406-512 MHz) of the Motorola trunking
system. You can receive these transmissions by checking the
trunking system’s control channel. You must program the
system’s base frequency and offset frequency to do this.
Notes
Notes