Filter
Top Products
73
Beyond the Basics
5. Press ENT for each entry. If you make a mistake, press CL
and enter the correct size code.
The default setting of the bank is for Motorola Type II.
However, if you set Type I and you want to return to Type
II, enter 15 at Step 4.
To confi rm the input, repeat Steps 1-5 and press ENT. Each
time you press ENT, you confi rm the size code. If you fi nd
an error, press CL and begin again at Step 1.
6. Press SCAN to start scanning.
talk group IDs
There are 10 talk group ID banks and each ID bank has 5 sub-
banks. Each sub-bank has 30 ID locations. You can program
up to 150 talk group IDs in each bank, so you can program up
to 1,500 talk group IDs in 10 banks. When the scanner stops
on a transmission in the Motorola, EDACS, or LTR mode, it
checks to see if the ID has been stored. In the closed mode,
the scanner only stops on the transmission and displays its
text tag if you have stored and not locked out the ID. In the
open mode, the scanner always stops on a transmission, but
it displays the ID’s text tag if you have stored the ID.
storing talk group IDs
To store a talk group ID, press TRUNK when the scanner stops
on a voice channel transmission or when a talk group ID is
indicated in the manual mode. The bottom line indicates
where the ID was stored (as ID save X-XX), then it changes to
ID#XXXX.
The fi rst X in ID save X-XX is the sub-bank number (0-4) in the
bank. XX is the number of IDs from (00-29) in each sub-bank.
If the ID has already been stored when you press TRUNK, ID
was saved appears.
Notes
Notes