49
BATT.Lo
appears.
The batteries are
weak.
Recharge rechargeable
batteries, or replace non-
rechargeable batteries.
PROBLEM POSSIBLE CAUSE REMEDY
RESETTING THE SCANNER
If the scanner’s display locks up or does not work properly after you
connect power, you might need to reset the scanner.
Caution:
This procedure clears all the information you have stored into
the scanner (such as frequencies and car numbers). Before you reset
the scanner, try turning it off and on to see if it begins working properly.
Reset the scanner only when you are sure it is not working properly.
1. Turn off the scanner.
2. While you hold down the
2
and
9
keys, turn on the scanner.
If you still have problems after resetting the scanner, take it to your lo-
cal RadioShack store.
Poor or no recep-
tion.
Batteries are weak
or dead.
Check the batteries, or
make sure the scanner
is plugged into a working
AC or DC outlet.
Error
appears. Frequency entered
incorrectly.
Re-enter the frequency
correctly, including the
decimal point.
While scanning, the
scanner locks on
frequencies that
have an unclear
transmission.
Stored frequencies
are the same as
“birdie” frequencies.
Avoid storing frequen-
cies listed under “Birdie
Frequencies” on
Page 41, or only listen to
them manually.
PROBLEM POSSIBLE CAUSE REMEDY
20-513.fm Page 49 Wednesday, August 4, 1999 2:39 PM