Filter
Top Products
Chapter 3
Internet Access in No Time
E-DOC-CTC-20050126-0005 v1.0
20
Terminating the Home
Install Wizard
1 The SpeedTouch™ Home Install Wizard will configure the SpeedTouch™ and
your PC according to the service profile. You can follow the configuration
progress in following window:
2 Finally, click Finish to close the wizard. After some seconds, the Internet LED
will be lit green. If not, refer to “5.2 LED Diagnostics” on page 33.
3 You will be redirected to the embedded SpeedTouch™ pages automatically
(unless you cleared the http://speedtouch.lan check box in the previous
window).
You can test your Internet connection as described in “3.3 Testing your
Internet Connection” on page 27.
IP settings The SpeedTouch™ DHCP server is enabled by default. Therefore, during the wizard
the computer’s networking interface, used during the Home Install Wizard procedure
is configured for obtaining its IP configuration dynamically.
These pages allow you to configure your firewall, your wireless access
point settings, and so on. More information can be found in the
SpeedTouch™ User’s Guide.
For fixed IP configurations, please follow the instructions of your ISP.