Filter
Top Products
134
Example:
To display the acquired trace information:
td (RET)
The display format of the branch trace information is as follows:
>td
IP TYPE ADDR MNEMONIC OPERAND
-D’xxxx BRANCH 00100100 JSR @ER0
-D’xxxx BRANCH 00100200 JMP @ER1
(a) (b) (c) (d) (e)
(a) Instruction pointer (signed decimal)
(b) Type of branch source
BRANCH: Branch source
(c) Address of instruction word
(d) Instruction mnemonic
(e) Instruction operand
The display format of the bus trace information is as follows:
>td start -10 end –5
CYCLE ADDRESS LABEL MNEMONIC OPERAND DATA R/W AREA STATUS CLOCK IRQ
-D'0010 00FF600C MOV.B @ER1,R4L 681C RD RAM PROG 1 0
-D'0009 00FF600E MOV.W @ER2,E4 692C RD RAM PROG 1 0
-D'0008 00FF6100 11 RD RAM DATA 1 0
-D'0007 00FF6010 MOV.L @ER3,ER5 0100 RD RAM PROG 1 0
-D'0006 00FF6104 5566 RD RAM DATA 1 0
-D'0005 00FF6012 6935 RD RAM PROG 1 0
(a) (b) (c) (d) (e) (f) (g) (h) (i) (j) (k)
(a) Cycle (signed decimal)
(b) Address
(c) Label
(d) Instruction mnemonic
(e) Instruction operand
(f) Data
(g) Read/write
(h) Access area
(i) Bus cycle status
(j) Bus cycle count
(k) IRQ pin