Filter
Top Products
144
20. Number of Software Breakpoint and [Stop At] Settings in the [Run...] Menu
The maximum number of software breakpoints and [Stop At] settings allowed in the [Run...]
menu is 255. Therefore, when 255 software breakpoints are set, specification by [Stop At] in
the [Run...] menu becomes invalid. Use the software breakpoints and [Stop At] in the [Run...]
menu with 255 or less total settings.
21. Note on RUN-TIME Display
The execution time of the user program displayed in the [Status] window is not a correct value
since the timer in the host computer has been used.
22. Note on Displaying COMMUNICATION TIMEOUT ERROR
If COMMUNICATION TIMEOUT ERROR is displayed, the emulator cannot communicate
with the MCU. Select [Initialize] from the [File] menu to initialize the emulator.
23. Note on Downloading Program
In the [Load Program] dialog box, which is opened when [Load Program…] is selected, the
verify function is invalid. After downloading the program, perform verify in the [Verify S-
Record File with Memory] dialog box, which is opened when [Verify] is selected from the
[Memory] menu.
24.
Support of Double Float Format
In the following memory operations, the double float format is not supported:
[Fill Memory] dialog box
[Search Memory] dialog box
MEMORY_FILL command
The [Format] specification in the [Copy Memory] dialog box is ignored. Memory is
copied in a byte unit.
25. Note on Continuous Step Execution
When the step is continuously executed by selecting [Step...] from the [Run] menu, do not use
the software breakpoint because this will cause the HDI to abnormally operate.
26. Note on Using the [Run program] Dialog Box
When [Run...] is selected from the [Run] menu to specify the stop address, there is the
following note:
When the breakpoint that has been set as Disable is specified as the stop address, note that
the breakpoint becomes Enable when the user program stops.
27. Note on Transition to Low-Power Consumption Mode
The hardware standby function must not be used. If it is not used, the emulator will not operate
normally.