Filter
Top Products
20
4. If the driver is not correctly connected, the following dialog box will be displayed.
Figure 2.16 [Unable to restore the previous driver settings] Dialog Box
The [E10A Driver Details] dialog box is displayed when the [OK] button is clicked.
Select the correct driver. For details, refer to section 6.4.1, Emulator Driver
Selection.
2.5.2 Writing H8S/xxxx E10A Flash memory Mode
In this mode the emulator is used as a flash memory writer. The following procedures apply when
[Writing H8S/xxxx E10A Flash memory] is selected from the activation modes listed in the
[Select Session] dialog box.
1. After the [System Clock] window appears, input the system clock frequency.
Figure 2.17 [System Clock] Dialog Box