M301N2T-PRB User’s Manual 5. Troubleshooting
REJ10J0037-0100 Rev.1.00 Mar.16, 2005
Page 42 of 48
5.2.2 Emulator Debugger Does Not Starts Up Properly (Target Connected)
Table 5.2 Checkpoints of errors when starting up the emulator debugger (target connected)
Error Checkpoint
ERROR 16005:
Can't connect with the target.
(1) Check the connection between the PC4701 and host machine.
See the PC4701 User's Manual
(2) Check that the PC4701 is powered on.
See the PC4701 User's Manual
(3) Check that all switch settings on the rear of the PC4701 and
interface cable settings of the emulator debugger match.
See the PC4701 User's Manual and the emulator debugger user's
manual (online manual)
ERROR 16211:
The version of M3T-PD30 and the firmware
on the target are not same.
(1) Check the connection between the PC4701 and the
M30100T3-RPD-E.
See the M30100T3-RPD-E user’s manual
(2) Download the proper firmware.
See "3.3 Downloading Firmware" (page 28)
(3) Choose the proper MCU file in the Init dialog box.
See the emulator debugger user's manual (online manual)
(4) Check that the descriptions in the MCU file are correct.
See "3.1.1 Making an MCU File" (page 25)
ERROR 16215:
Cannot communicate with the debugging
monitor.
Please execute RESET command.
(1) Check the connection between the PC4701 and the
M30100T3-RPD-E.
See the M30100T3-RPD-E user’s manual
(2) Check the connection between the M30100T3-RPD-E and this
product.
See "2.4 Connecting the M30100T3-RPD-E" (page 22)
(3) Check that the reset pin of the user system is at “H” level.
See the MCU specifications.
(4) Check that the oscillator circuit of the emulation pod is oscillating
properly.
See the M30100T3-RPD-E user’s manual
ERROR 16014:
Communication ERROR.
Can't accept data.
(1) Check that the oscillator circuit of the user system is oscillating
properly.
See "2.1.3 Using the Oscillator Circuit on the User System " (page
18)
(2) Check that the PC4701 LEDs at startup show normal operation.
See "3.2.3 LED Display When the Emulator Starts Up Normally"
(page 27).
ERROR 16231:
There was sent undefined data from the
emulator.
Check that the emulator debugger has not been started up without
shutting down the PC4701.
See "4.4 Notes on Using This Product: Note on Quitting the Emulator
Debugger" (page 36).