Filter
Top Products
Copying
20
2
-How to operate
❖ To stop the machine during a multi-
copy run.
Press the {Clear/Stop} key.
❖ To return the machine to the initial
condition after copying.
Press the {Clear Modes} key.
❖ When clearing entered values.
Press the {Clear/Stop} key or [Clear]
on the display.
❖ To check the settings.
Press the {Check Modes} key.
Interrupt Copy
Use this function to interrupt a long
copy job to make urgently needed
copies.
Limitation
❒ You cannot use Interrupt Copy
with the scanner function, or when
fax originals are being scanned.
A Press the {Interrupt} key.
The Interrupt indicator lights.
When the originals stop scanning
A Remove the originals that were
being copied, and then place
the originals you want to copy.
B Press the {Start} key.
Copying starts.
C When copying is complete, re-
move the originals and copies.
D Press the {Interrupt} key again.
The Interrupt indicator goes
out.
E
When the display prompts you,
place the former set of origi-
nals again.
F Press the {Start} key.
Note
❒ The former copy job's set-
tings are restored and the
machine continues copying
from where it left off.
When the machine keeps
copying
A Place the originals you want to
copy.
B Press the {Start} key.
The machine stops the previous
job and starts copying the new
originals.
C When copying is complete, re-
move originals and copies.
D Press the {Interrupt} key again.
The Interrupt indicator goes
out.
The former copy job's settings
are restored and the machine
continues copying from where
it left off.
Left Original Beeper
The beeper sounds and an error mes-
sage appears if you leave originals on
the exposure glass after copying.
Note
❒ See p.96 “Tone: Original remains”.
RuC4_AE_Copy-F_FM_forPaper.book Page 20 Thursday, April 14, 2005 1:21 PM