Filter
Top Products
C-10 Paper Specifications
Prepunched Paper
Prepunched paper should be flat and without deformation. Do not use paper with
ragged or damaged hole edges. Any paper pieces resulting from the punching operation
and paper dust should be removed before using.
Use prepunched paper with holes that conform to the following specifications:
Maximum of four holes.
Maximum hole diameter of 8.0 mm (0.315 in.).
Holes must not be located in or protrude into the shaded area shown below.
5 mm
(0.2 in)
5 mm
(0.2 in)
5 mm
(0.2 in)
5 mm
(0.2 in)