Rosewill RNX-GX4 Network Router User Manual


 
Wireless Router RNX-GX4 User’s Manual
36
h Authentication Type: The default is set to “Auto Select”, which allows
Open System” or “Shared Key” authentication to be used. Select
Shared Key” if you only want to use “Shared Key” authentication (the
sender and recipient both must use the same WEP key for
authentication).
h Fragmentation Threshold: This value specifies the maximum size for a
packet before data is fragmented into multiple packets. You should
leave this value in the 256 to 2346 range. In most cases, it should
remain as its default value of 2346. Setting the Fragmentation
Threshold too low may result in poor network performance.
h RTS Threshold: You can set RTS Threshold value in this field, the valid
range should be 256-2347 and default value is 2347. If a network
packet is smaller than the preset RTS threshold size, the RTS/CTS
mechanism will not be enabled.
h DTIM Interval: The “DTIM Interval” indicates the interval of the
Delivery Traffic Indication Message, you can set this value in the
20-1000 range, and the default value is 100.
h Transmit Rate: Transmit rate indicates the transmission speed of
wireless LAN access .The default setting is “Auto” and you can set this
value between 1 – 54Mbps range.
h 802.11g Protection: Using 802.11b and 802.11g mixed mode may
result in poor network performance. By enabling the 802.11 protection,
it will improve performance of 802.11g devices in your wireless
network.
h Preamble Type: "Short Preamble" is suitable for heavy traffic wireless
network which will significantly increase the throughput performance at
higher data rates. While "Long Preamble" provides more
communication reliability and will ensure maximum stability of the
connection; the default setting is “Long Preamble”.
h AP Isolation: Create separate virtual networks for your wireless
network. After enable this function, every wireless client will in its own
virtual network and can not access each other. If many users access
your wireless network frequently, you should enable this function.
3.5.2 Secondary AP Setup
Secondary AP Setup defaults as Disable, when you enable it, this function will
look very similar to the Primary AP Setup. However, please do name the SSID